Hybrid organosilazane/organosilylamine telechelic oligomers—I. Two-dimensional NMR spectroscopy characterization of dimethylsilylethylenediamine oligomers

The detailed characterization of multifunctional hybrid organosilazane/organosilylamine telechelic oligomers by IR and ¹H, ¹³C and ²⁹Si NMR spectroscopy in one and two dimenions has been undertaken. The specific multifunctional oligomers, comprising NH/NH₂ or SiCl functionalities depending on the monomer feed-ratio, were prepared from mono- and di-functionally reacted dichlorodimethylsilane (DDS) and mono-, di-, tri- and tetra-functionally reacted ethylenediamine (EDA). Varying the feed-ratio afforded control of the microstructures of the oligomers and the preparation of oligomers with, in some cases, conterminously located silicon–chlorine (SiCl) groups. The combination of the NMR methods with the IR technique has enabled the detailed microstructural characterization of the oligomers and the identification of the functionalities therein. This approach and the knowledge gained from the DDS/EDA system has been applied to the microstructural characterization of other hybrid organosilazane/silylamine preceramic telechelic oligomers.     

Physico-Chemical Characterization of Yu Guo Beads(1100-771 B. C. ) in China

When was the earliest glass produced in China? This has still been a question so far. Some archaeologists have thought that Yu Guo beads are real glass, the earliest glass(1100-771 B. C. ) in China. However, more details of scientific investigations in this paper show that Yu Guo beads are mainly made of clastic quartz (>95%) with a small amount of clay and sintered under the low temperature(500-600℃). It is not a glassy body, but a kind of polycrystal ornaments.     

Study of archaeological ceramics by total-reflection X-ray fluorescence spectrometry: Semi-quantitative approach

Total-reflection X-ray fluorescence spectrometry has been compared with Instrumental Neutron Activation Analysis in order to test its potential application to the study of archaeological ceramics in the archaeometric field. Two direct solid non-chemical sample preparation procedures have been checked: solid sedimentation and solid chemical homogenization. For sedimentation procedure, total-reflection X-ray fluorescence allows the analysis of the elemental composition with respect to the size fraction but not the average evaluation of the composition. For solid chemical homogenization procedure, total-reflection X-ray fluorescence provides precise (from 0.8% to 27% of coefficient of variation) and accurate results (from 91% to 110% of recovery) for 15 elements (Cr, Hf, Ni, Rb, Al, Ba, Ca, K, Mn, Ti, V, Cu, Ga, Y and Fe) with an easy sample preparation process of the solid clay and without previous chemical treatment. The influence of the particle sizes has been checked by total-reflection X-ray fluorescence sample angle scans and anomalous behaviors have been found for three additional detected elements: As, Sr and Zn, which can be attributed to interference effects of the mineral grain sizes of their associated chemical phases in the total-reflection X-ray fluorescence interference region. The solid chemical homogenization procedure produces data useful for archaeological interpretation, which is briefly illustrated by a case-study. Finally, the decantation procedure data can be also useful for size chemical speciation and, consequently, for alternative environmental total-reflection X-ray fluorescence applications.     

Thermal and chemical nanofractal relaxation

We studied shape relaxation of nano-fractal islands, during annealing, after their growth from antimony cluster deposition on graphite surface. Annealing at 180^°C shows evidence of an increase of the fractal branch width with time followed by branch fragmentation, without changing the fractal dimension. The time evolution of the width of the arm suggests the surface self-diffusion mechanism as the main relaxation process. With Monte Carlo simulations, we confirmed the observed behavior. Comparison is done with our previous results on fragmentation of nano-fractal silver islands when impurity added to the incident cluster promotes rapid fragmentation by surface self-diffusion enhancement [1].     

Influence of silicon on the microstructure and mechanical properties of Zr-Si-N composite films

A series of Zr-Si-N composite films with different Si contents were synthesized in an Ar and N₂ mixture atmosphere by the bi-target reactive magnetron sputtering method. These films’ composition, microstructure and mechanical properties were characterized by energy dispersive spectroscopy, X-ray diffraction, scanning electron microscopy, atomic force microscopy and nanoindentation. Experimental results revealed that after the addition of silicon, Si₃N₄ interfacial phase formed on the surface of ZrN grains and prevented them from growing up. Zr-Si-N composite films were strengthened at low Si content with the hardness and elastic modulus reaching their maximum values of 29.8 and 352 GPa at 6.2 at% Si, respectively. With a further increase of Si content, the crystalline Zr-Si-N films gradually transformed into amorphous, accompanied with a remarkable fall of films’ mechanical properties. This limited enhancement of mechanical properties in the Zr-Si-N films may be due to the low wettability of Si₃N₄ on the surface of ZrN grains.     

机械密封焊接金属波纹管膜片结构的有限元分析

在Linux操作平台下应用FAST_wmg有限元前后处理软件对机械密封焊接金属波纹管膜片建立了有限元模型并进行了非线性有限元分析．在同等条件下对焊接金属波纹管采用了S型膜片和V型膜片，并分别进行了有限元强度评价和对比分析．结果表明，两种膜片最大应力集中都在膜片两端周围发生．这与文献所叙述的波纹管的主要失效发生在膜片两端与焊谷接近的部位非常吻合，但是，在同样边界条件下，在同样位移量时S型膜片最大应力值比V型膜片最大应力值小，压缩量大．     

Structure and mechanical properties of Al/AlN multilayer with different AlN layer thickness

Nanometer scale Al/AlN multilayers have been prepared by dc magnetron sputtering technique with a columnar target. A set of Al/AlN multilayers with the Al layer thickness of 2.9 nm and the AlN layer thickness variation from 1.13 to 6.81 nm were determined. Low angle X-ray diffraction (LAXRD) was used to analyze the layered structure of multilayers. The phase structure of the coatings was investigated with grazing angle XRD (GAXRD). Mechanical properties of these multilayers were thoroughly studied using a nanoindentation and ball-on-disk micro-tribometer. It was found that the multilayer hardness and reduced modulus showed no strong dependence on the AlN layer thickness. Al2.9 nm/AlN1.13 nm multilayer had more excellent tribological properties than single layers and other proportion multilayers with a lowest friction coefficient of 0.15. And the tribological properties of all the multilayers are superior to the AlN single layer.     

具有高机械强度的掺Er~(3 )∶TeO_2-Nb_2O_5玻璃的光谱性质研究

熔制了掺铒碲铌玻璃样品(100-X)TeO2-XNb2O5(X=5,10,15,20mol%),测试了其密度、折射率、转变温度、析晶温度、维氏机械强度、吸收光谱、荧光光谱、荧光寿命等参量。利用Judd-Ofelt和McCumber理论分别计算了铒离子强度参量Ωt(t=2,4,6)和受激发射截面σemi的大小,研究了掺铒碲铌玻璃样品光谱参量对Nb2O5成分的依赖性,并与典型的碲锌钠玻璃(75TeO2-20ZnO-5Na2O)在热学、机械强度、光谱性质和放大品行四个方面进行了比较.     

A new microtensile tester for the study of MEMS materials with the aid of atomic force microscopy

An apparatus has been designed and implemented to measure the elastic tensile properties (Young's modulus and tensile strength) of surface micromachined polysilicon specimens. The tensile specimens are “dog-bone” shaped ending in a large “paddle” for convenient electrostatic or, in the improved apparatus, ultraviolet (UV) light curable adhesive gripping deposited with electrostatically controlled manipulation. The typical test section of the specimens is 400 μm long with 2 μm×50 μm cross section. The new device supports a nanomechanics method developed in our laboratory to acquire surface topologies of deforming specimens by means of Atomic Force Microscopy (AFM) to determine (fields of) strains via Digital Image Correlation (DIC). With this tool, high strength or non-linearly behaving materials can be tested under different environmental conditions by measuring the strains directly on the surface of the film with nanometer resolution.     

具有高机械强度的掺Er3+∶TeO2-Nb2O5玻璃的光谱性质研究

熔制了掺铒碲铌玻璃样品(100-XTeO2-XNb2O5(X=5,10,15,20 mol%)，测试了其密度、折射率、转变温度、析晶温度、维氏机械强度、吸收光谱、荧光光谱、荧光寿命等参量。利用Judd-Ofelt和McCumber理论分别计算了铒离子强度参量Ωt (t=2, 4, 6)和受激发射截面σemi的大小，研究了掺铒碲铌玻璃样品光谱参量对Nb2O5成分的依赖性，并与典型的碲锌钠玻璃（75TeO2-20ZnO-5Na2O）在热学、机械强度、光谱性质和放大品行四个方面进行了比较.